Renesas E1E20 Self Check Program 1.01

Renesas E1E20 Self Check Program is a diagnostic utility from Renesas Electronics Corporation designed to verify the basic health and connectivity of E1 and E20 on-chip debugging emulators. It helps you confirm that the emulator hardware, USB connection, drivers, and essential control signals are functioning correctly before you start a debug session.

Key capabilities:

• Automatically detects connected E1/E20 units over USB and validates communication.
• Confirms driver installation and reads key device information, including firmware details.
• Performs basic control-signal and voltage-sense checks to ensure the emulator can interface with a target system.
• Presents clear pass/fail results and can generate a concise log to assist in troubleshooting or support requests.
• Provides a guided, step-by-step workflow requiring no project setup.

Typical uses:

• Initial setup verification to ensure your development environment recognizes the emulator.
• Quick isolation of issues when a debugger fails to connect in tools such as e2 studio or CS+.
• Post-maintenance checks after replacing cables, updating software, or moving to a new PC.

How to run:

1. Install the required Renesas drivers for the E1/E20.
2. Connect the emulator to your PC via USB.
3. Launch the Renesas E1E20 Self Check Program and follow the on-screen instructions.
4. Review the summary to confirm the emulator passes all tests.

Note: This tool validates the emulator and its connection to the PC. It does not diagnose target board hardware or application-level issues.

Renesas E1E20 Self Check Program is developed by Renesas Electronics Corporation and is used by 2 users of Software Informer. The most popular version of this product among our users is 1.0. The name of the program executable file is E1E20SCP.exe.

You can check Check Printer, Star Check Writer, Instant Check and other related programs like Ashampoo MP3 Check & Convert at the "download" section.